Troubleshooting; Service - Hoover TaskVac Commercial Guide D'utilisation

If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the
checklist below.
Any other servicing should be done by an authorized service representative.
If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take
it to a service center prior to continuing use.
To reduce risk of personal injury - Unplug vacuum before servicing.
PRoBleM PossiBle Cause
Vacuum won't 1. Power cord not firmly plugged into outlet.
run
2. Blown fuse or tripped breaker.
3. Thermal Protector activated.
System Check 1.Rinsable Filter and/ or Filter
Indicator has
turned red
2. Dirt cup full and/ or clogged.
or
Vacuum won't
3. Broken or worn belt.
pick up
or
4. Brushroll and/ or Hose clogged.
Low suction
5. Carpet height setting is incorrect.
Dust escaping
1. Dirt cup full.
from vacuum
2. Dirt cup not installed correctly.
3. Hose not installed correctly.
4. Rinsable and/ or Filter made with
HEPA media not installed completely.
Vacuum is
1. Carpet height setting is
difficult to push
or won't move
forward
Smoky/burning 1. Belt broken or stretched.
smell detected
2. Brushroll is clogged.
To obtain approved Hoover
Warranty Service Dealer (Depot) by:
• Checking the Yellow Pages under "Vacuum Cleaners" or "Household".
• Visit our website at hoover.com (U.S. Customers) or hoover.ca (Canadian customers).
Follow the service center link to find the service outlet nearest you.
• For an automated referral of authorized service outlet locations call 1-800-944-9200.
Do not send your vacuum to Hoover
If you need further assistance:
To speak with a customer service representative call 1-800-944-9200; Mon-Fri 8am-7pm EST. Always
identify your vacuum by the complete model number when requesting information or ordering parts. (The
model number appears on the bottom of the vacuum.)

5. tRouBlesHootinG

WARNING
!
made with HEPA media is dirty.
incorrect.
service and genuine Hoover
®
, Inc., Company in Glenwillow for service. This will only result in delay.
®
PossiBle solution
1. Plug unit in firmly.
2. Check fuse or breaker in home. Replace
3. Unplug and allow vacuum to cool for 30min.
(This willl reset the thermal protector)
1. Clean Rinsable Filter and or Filter made
2. Empty dirt cup - Pg. 9.
3. Replace belt - Pg.12.
4. Check Hose - Pg. 11. Check Brushroll - Pg.11.
5. Set Carpet Height Adjustment to appropri-
ate setting for carpet being cleaned - Pg.7.
1. Empty dirt cup - Pg. 9.
2. Review Dirt Cup removal & replacement
- Pg. 9.
3. Review Hose installation - Pg. 7.
4. Review Filter Removal and Cleaning - Pg.
9 and 10.
1. Set Carpet Height Adjustment knob to
appropriate setting for carpet being cleaned
- Pg. 7.
1. Replace brushroll belt - Pg. 13.
2. Clear/ remove debris from brushroll - Pg. 11.

6. seRViCe

parts, locate the nearest Authorized Hoover
®
13
!
fuse/reset breaker in home.
with HEPA media - Pg. 9 and 10.
®