Step 6, Position Water Line And House Wiring; Step 7 Install Drain Hose, Guide Through Cabinet - GE Monogram ZBD6800 Instructions D'installation

Lave-vaisselle encastré. pour zbd6890 et zbd0700, consulter aussi les instructions imprimées sur le gabarit fourni avec ce modèle.
Masquer les pouces Voir aussi pour Monogram ZBD6800:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

STEP 6
POSITION WATER LINE
AND HOUSING WIRING
• Position water supply line and house wiring on the
floor of the opening to avoid interference with base
of dishwasher and components under dishwasher.
5"
Water
Figure M
Line
STEP 7
INSTALL DRAIN HOSE,
GUIDE THROUGH CABINET
• Remove tape and wire tie holding the clamp to the
drain hose. Be careful not to damage the drain hose.
• Stand the dishwasher upright.
• Slip the supplied
hose clamp over
the large end of
the hose. Do not
tighten.
Figure N
• Push hose over the drain outlet on the back side of
the dishwasher. See illustration. Push the hose over
the outlet and against the shoulder stop.
• Tighten the hose clamp with a 1/4" nut driver.
Insulation
Blanket
Figure O
• Position the dishwasher in front of the opening.
Insert drain hose into the cabinet side. If power cord
is used, guide the end through a separate hole.
Installation Instructions
5" 4"
4"
6"
House
Wiring
Drain
Shoulder
Outlet
Stop
Hose
Clamp
Flapper
Valve—Do
Not Remove
Water
Line
Drain
Hose
House
Wiring
Power Cord
(If Used)
STEP 8
SLIDE DISHWASHER
PARTIALLY INTO CABINET
DO NOT PUSH AGAINST FRONT PANEL WITH KNEES.
DAMAGE WILL OCCUR.
• Slide dishwasher into the opening a few inches
at a time.
Do Not Push Against
Front Door Panel With
Knee. Damage to The
Door Panel Will Occur.
• As you proceed, pull the drain hose through the
opening under the sink. Stop pushing when the
dishwasher is a few inches forward of adjacent
cabinetry.
• Make sure drain hose is not kinked under the
dishwasher and there is no interference with the
water line and wiring or any other component.
STEP 9
INSTALL TRIM PIECES
Skip this step if trim is not supplied with the
dishwasher.
• Locate trim strips inside dishwasher.
• Press trim onto the tub flange on each side. Start
with the top edge, pressing on as you move towards
the bottom.
• Press the two top trim pieces on each side of
the latch.
• Open and close the door to check that trim does not
bind and does not interfere with door latch.
Trim Strip
Trim
Strip
Figure Q
9
Reposition Dishwasher
by Grasping Both
Sides With Hands
Figure P
Trim
Strip

Publicité

Chapitres

Table des Matières
loading

Table des Matières