How To Install The Fork - SR Suntour AXON werx ELD 15 Mode D'emploi

SR SUNTOUR - OWNERS MANUAL

HOW TO INSTALL THE FORK

Cut the steerer tube. To get the correct
lenth, take the old steerer and measure it
against the new one.
Note: Take note of the „Min Cut Line"
which is indicated on the steerer tube.
Burr the cutting egdes. This operation is
very important to avoid any damages on
the O-rings.
Install the crown race part of the head
set onto the steerer tube. To do so use a
crown race setter tool.
Insert the electric cables(one is for the
motor and one for the switch) through
the gasket from the side where there is no
groove.
After inserting the electric cables through
the gasket, pass them through the steerer
tube to the top.
AXON werx ELD
9
English