Optional Accessories; After Use - Makita DLS211 Manuel D'instructions

4. Return the handle to the original position and
secure the workpiece with the vertical vise so that the
workpiece does not move from the position you have
determined.
5. Install the batteries and turn on the laser switch.
6. /RRVHQ WKH DGMXVWLQJ VFUHZ 7R PRYH WKH ODVHU OLQH
DZD\ IURP WKH EODGH WXUQ WKH UDQJH DGMXVWPHQW VFUHZV
counterclockwise. To move the laser line close to the
EODGH WXUQ WKH UDQJH DGMXVWPHQW VFUHZ FORFNZLVH
Adjusting the laser line on the left side of the blade
Fig.85: 1. $GMXVWLQJ VFUHZ 2. 5DQJH DGMXVWPHQW
screw 3. Hex wrench 4. Laser line 5. Saw
blade
Adjusting the laser line on the right side of the
blade
Fig.86: 1. $GMXVWLQJ VFUHZ 2. 5DQJH DGMXVWPHQW
screw 3. Hex wrench 4. Laser line 5. Saw
blade
7. 6OLGH WKH DGMXVWLQJ VFUHZ WR WKH SRVLWLRQ WKDW WKH
laser line comes onto the cutting line and then tighten it.
NOTE: The movable range of laser line is factory
DGMXVWHG ZLWKLQ  PP  IURP WKH VLGH VXUIDFH RI
saw blade.
Cleaning the laser light lens
The laser light becomes hard to see as the lens for
the laser light gets dirty. Clean the lens for laser light
periodically.
Fig.87: 1. Screw 2. Lens
Remove the batteries. Loosen the screw and pull out
the lens. Clean the lens gently with a damp soft cloth.
NOTICE:
Do not remove the screw which
secures the lens. If the lens does not come out,
loosen the screw further.
NOTICE:
Do not use solvents or any petro-
leum-based cleaners on the lens.

After use

After use, wipe off chips and dust adhering to the tool
with a cloth or the like. Keep the blade guard clean
according to the directions in the previously covered
section titled "Blade guard". Lubricate the sliding por-
tions with machine oil to prevent rust.
OPTIONAL
ACCESSORIES
WARNING:
These Makita accessories or
attachments are recommended for use with your
0DNLWD WRRO VSHFL¿HG LQ WKLV PDQXDO The use of
any other accessories or attachments may result in
VHULRXV SHUVRQDO LQMXU\
WARNING:
Only use the Makita accessory
or attachment for its stated purpose. Misuse of
an accessory or attachment may result in serious
SHUVRQDO LQMXU\
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Steel & Carbide-tipped saw blades
• Vertical vise
• Horizontal vise
• Crown molding stopper set
• Dust bag
• Triangular rule
• Hex wrench
‡ +H[ ZUHQFK IRU ODVHU DGMXVWPHQW
‡ :LUHOHVV XQLW IRU '/6
• Makita genuine battery and charger
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
39 ENGLISH