Leveling; Door Mullion And Auto Open Door; Door Alignment; Adjusting Door Height - LG SIGNATURE URNTS3106N Manuel Du Propriétaire

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

NOTE
The front leveling legs must be extended
fully so they are in firm contact with the
floor (even if leveling or door alignment
is not needed).

Leveling

After installing, plug the refrigerator's power
cord into a 3-prong grounded outlet and push
the refrigerator into the final position.
The refrigerator has two front leveling legs—
one on the right and one on the left. Adjust the
legs to alter the tilt from front-to-back or side-
to-side. If the refrigerator seems unsteady, or
you want the doors to close more easily, adjust
the refrigerator's tilt using the instructions
below:
1
Turn the leveling leg to the left to raise
that side of the refrigerator or to the right
to lower it. It may take several turns of the
leveling leg to adjust the tilt of the
refrigerator.
NOTE
A flare nut wrench works best, but an
open-end wrench will suffice.
Do not over-tighten.
2
Open both doors again and check to make
sure that they close easily. If the doors do
not close easily, tilt the refrigerator slightly
more to the rear by turning both leveling
legs to the left. It may take several more
turns, and you should turn both leveling
legs the same amount.
Door Mullion and Auto Open
Door
Once the door bins are filled, the doors may
become misaligned, preventing the door
mullion or the Auto Open Door function from
working properly.
If the mullion on the left refrigerator door does
not open and close properly or the right door
stays ajar after the Auto Open Door function,
follow the directions below.
1
Make sure both front leveling legs are
extended fully and in firm contact with the
floor.
2
Follow the instructions in the Door
Alignment section to raise the left
refrigerator door until the door mullion is
once again working properly.
3
Adjust the right refrigerator door so it
aligns with the left refrigerator door.

Door Alignment

If the floor is not flat, the door heights may
differ. In this case, use the following method
to adjust the difference.

Adjusting Door Height

Adjusting Fridge Door
Height
Height difference
Adjusting Freezer
Door Height
Height difference
INSTALLATION
21
Open the fridge door
and use a wrench to
rotate the door hinge
bolt as shown.
Fridge door
Freezer door
Open the freezer door
and use a wrench to
rotate the door hinge
bolt as shown.
Freezer door

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Urntc2306nUrntc2306n.agrcna0

Table des Matières