Leveling; Door Alignment; Adjusting Door Height - LG SIGNATURE LUPXS3186N Manuel Du Propriétaire

Leveling

After installing, plug the refrigerator's power
cord into a 3-prong grounded outlet and push
the refrigerator into the final position.
The refrigerator has two front leveling legs—
one on the right and one on the left. Adjust the
legs to alter the tilt from front-to-back or side-
to-side. If the refrigerator seems unsteady, or
you want the doors to close more easily, adjust
the refrigerator's tilt using the instructions
below:
1
Turn the leveling leg to the left to raise
that side of the refrigerator or to the right
to lower it. It may take several turns of the
leveling leg to adjust the tilt of the
refrigerator.
NOTE
A flare nut wrench works best, but an
open-end wrench will suffice.
Do not over-tighten.
2
Open both doors again and check to make
sure that they close easily. If the doors do
not close easily, tilt the refrigerator slightly
more to the rear by turning both leveling
legs to the left. It may take several more
turns, and you should turn both leveling
legs the same amount.

Door Alignment

If the floor is not flat, the door heights may
differ. In this case, use the following method
to adjust the difference.

Adjusting Door Height

Adjusting Fridge Door
Height
Height difference
Adjusting Freezer
Door Height
Height difference
INSTALLATION 21
Open the fridge door
and use a wrench to
rotate the door hinge
bolt as shown.
Fridge door
Freezer door
Open the freezer door
and use a wrench to
rotate the door hinge
bolt as shown.
Freezer door