Industry Canada Statement - LG SIGNATURE LUPXS3186N Manuel Du Propriétaire

30 HOW TO USE
FCC Regulation Notice
This device complies with Part 18 of the FCC
Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference
and
(2) this device must accept any interference
received, including interference that may
cause undesired operation of the device.
Any changes or modifications in construction of
this device which are not expressly approved by
the party responsible for compliance could void
the user's authority to operate the equipment.
This device has no serviceable parts.
This equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the
equipment and the receiver.
- Connect the equipment to an outlet on a circuit
different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV
technician for help.
Model
LUPXS3186N
LUPXC2386N

Industry Canada Statement

This device complies with Industry
Canada'slicense-exempt RSSs. Operation is
subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference,
including interference that may cause
undesired operation of the device.
CAN RSS-216 / CNR-216
FCC ID
BEJF31GDA
BEJF23GDA07
Wireless Power Transfer Specifications
Frequency 350 kHz ± 20kHz
Rated voltage DC 12V
Delivered power Less than or equal to 1.2W
per shelf
Transmission Electromagnetic induction
mode
Receiver
NOTE
Installing the shelf on the right side will
y
disable the shelf light.
The shelf light turns on only when the
y
shelf is installed in the highest or lowest
positions.
Foreign objects and dirt between the shelf
y
and the inner cabinet wall could prevent
the shelf light from turning on.
The shelf light turns on when the door is
y
opened.
The shelf light turns off after seven
y
minutes or when the door is closed.
Transmitter