Connecting The Water Line; Before You Begin - LG SIGNATURE URNTS3106N Manuel Du Propriétaire

5
Hold the water supply connection and
gently push in the collet to connect the
water supply line as shown in
5
the tube at least /
8
connector.
6
Position the cover in its place. Insert and
tighten the cover screws.
NOTE
Collet
Tube
Insert Line
1) Gently insert the tube until only one
line shows on the tube.
2) Pull the tube to make sure that the
tube is tightly fastened.
. Insert
inch (15 mm) into the
Collet
(Correct)
(Incorrect)

Connecting the Water Line

Before You Begin

This water line installation is not covered by the
refrigerator warranty. Follow these instructions
carefully to minimize the risk of expensive water
damage.
Water hammer (water banging in the pipes) in
house plumbing can cause damage to refrigerator
parts and can lead to water leakage or flooding.
Call a qualified plumber to correct water hammer
before installing the water supply line to the
refrigerator.
CAUTION
To prevent burns and product damage,
only connect the refrigerator water line to
a cold water supply.
If you use your refrigerator before connecting
the water line, make sure the icemaker power
switch on the control panel is in the OFF
position.
CAUTION
Do not install the icemaker tubing in
areas where temperatures fall below
freezing.
INSTALLATION 17