Part Replacement - Kamado Joe PELLET JOE Mode D'emploi

Part Replacement

PIT PROBE REPLACEMENT
1 Remove the damaged probe, reinstall the Pit probe.
2 Make sure to plug the new probe into the corresponding probe
port behind the grill.
IGNITOR PROBE REPLACEMENT
1 Remove the two thumb screws that secure the firebox.
2 Lift out the firebox and unscrew the small set-screw
underneath the firebox. Reach into the grill crucible area and
un-clip the igniter wire
3 Replace the damaged ignitor probe, tighten the set screw, and
secure the firebox. Igniter should protrude into the firebox by
3/4" (20MM)
Ignitor Probe
Pit Probe
set screw
21
Firebox