Cafe CSB42 Manuel D'utilisation Et D'installation page 25

WATER LINE
STEP 4
INSTALLATION WITH A REVERSE
OSMOSIS SYSTEM OR OTHER
HOUSEHOLD FILTRATION SYSTEM
Skip this step when not using an RO System or
other household filtration system.
If the water supply to the refrigerator is from a
household filtration system, use the refrigerator's filter
bypass plug. Using the refrigerator's water filtration
cartridge with the RO filter can result in hollow ice
cubes.
Rotate Counterclockwise to Remove
STEP 5 INSTALL SIDE PANELS
Skip this step when not using side panels.
should be inserted into the case trim. Fasten the
panels to the refrigerator with stick-on hook and loop
fastener strips before setting the refrigerator in place.
STEP 6 ANTI-TIP PROCEDURE
WARNING
These refrigerators are top heavy, especially with
any doors open, and must be secured to prevent
tipping forward which could result in death or
serious injury. Read and follow the entire installation
instructions for securing the refrigerator with the
anti-tip system.
long and secure
the block to the
mounting brackets
provided using #12
or #14 wood screws.
• Secure the bracket
with wood block to
the back wall so that
from the finished
floor. Use #12 or
#14 wood screws. See the illustration.
24
Installation Instructions
Filter Bypass
Plug
Tip Over Hazard.
STEP 6 ANTI-TIP PROCEDURE
(Cont.)
• The screws must penetrate at least one inch into
the vertical wall studs.
• If metal wall studs, use self-tapping sheet metal
screws in place of wood screws.
IMPORTANT: When the refrigerator is installed
under a soffit or if there is not enough height for
this method of security, brackets cannot be used.
Proceed to step 7 to level the refrigerator and then
to step 8 to secure refrigerator to cabinets.
refrigerator must be secured to prevent tipping.
Connect power cord:
• Before pushing the refrigerator into the opening,
plug the power cord into the receptacle. The water
filter guard will need to be removed for access
(some models). Remove the 3 screws holding it
in place. If access is still too tight, remove the 2
screws holding the water filter bracket and move
aside. Open the grille panel and reach into the
opening at the back to grasp the power cord. Pull
the power cord into the opening as you push the
refrigerator back. Secure the bracket and guard
with the original screws.
• Gently push refrigerator into the opening with hands
against front corners.
The
49-1000361 Rev. 2