Panel Installation; Wired Controller Installation - Gree GMV-ND22TD/A-T Manuel D'utilisateur

4.4.2 Panel installation

(1) Remove the grille from the panel, and then open the horizontal louver.
(2) Aim the screw hole on panel at the corresponding screw hole on main unit.
(3) Screw up the screws on corresponding holes and then install the coresponding screw cover.
(4) Close the horizonl lover, connect the butt terminal and arrange the wires.
(5) Install the grille.

4.5 Wired controller installation

Wired controller is optional accessory. If wired controller is needed, please contact your local
dealer and install the wired controller according to the instruction manual.
Note:
Do perform the commissioning operation before first use, automatic addressing or other settings,
please refer to the manual of ODU.
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
Multi Variable Air Conditioners One-way Cassette Type Indoor Unit
Tighten screws
Install screw cap
Indoor unit
Ceiling
Air outlet
Sealing mater
5-8mm
⑤
Decoration panel
13
Grille