Enarco TEN2540 Manuel D'instructions page 52

7.4 CHANGING THE ENGINE OIL
7.4.1.
7.4.2.
7.4.3.
HONDA MOTOR :
7.4.4.
7.4.5.
7.4.6.
7.4.7.
en
HATZ MOTOR:
7.4.8.
7.4.9.
7.4.10.
7.4.11.
!
To check the oil level, remove the dipstick, clean off, replace screwing back the plug and finally take
it out again and check the level on the dipstick. Where necessary, refill up to the maximum level.
20 TEN2540-TEN2550-TEN3040-TEN3050
THE MOTOR SHOULD BE LEVEL AND STOPPED.
Drain the oil while the motor is still warm to help it empty out quickly and completely.
Place a receptacle underneath the motor to collect the oil.
Unscrew the filler plug and the drainage plug and empty out into a receptacle.
Screw the drainage plug up tightly.
Pour the recommended oil in until it reaches the level (see point 4.1 ENGINE
SPECIFICATONS)
Screw the filler plug tightly into place.
Place a receptacle underneath the motor to collect the oil.
Remove the drain plug and wait until all the oil has drained out.
Clean the drain plug, fit a new washer and tighten up again (50Nm).
Add engine oil. (see section on technical specifications)
:
PRECAUTION Use current standard procedures for managing the residual oil.
OIL PLUG /
DIPSTICK
DRAINAGE
PLUG LEVEL
Honda/Robin motor
Hatz motor
REVERSIBLE PLATE COMPACTORS