Suunto ADVIZOR Manuel D'instructions page 35

5. At the minutes desired, PRESS the [Mode] button to accept the changes and exit the setup program.
The dual time setup is complete.
The dual time stays the same, even though the time in the main time mode is adjusted. For example, if you set
the dual time to show your home time, your home time will always be displayed in this sub mode even though
you travel to a different time zone and adjust the time in the main time mode.
Note: The dual time function is completely independent and does not effect the alarms or the memory functions.
These are dependent on the current local time.
CHAPTER 4 ALTIMETER MODE
The Suunto Wristop Computer Altimeter function provides the user with:
• an adjustable unit of measure either meter or feet: meter ranging from -500 to 9,000; ft ranging -1,600 to
29,500;
• a resolution of 5m or 10ft;
• a display update on the rate of vertical movement in intervals of one second for 3 minutes, then every 10
seconds or less;
• a difference measurement function allowing zeroing of the altimeter for following vertical progress between
stages;
• an automatic 24-hour memory in one hour intervals showing altitude and vertical ascent/descent rate; and
• A logbook of recordings storing total vertical ascent/descent, average vertical ascent/descent rate, number
of runs (e.g. skied), duration of log, as well as minimum, maximum and average heart rate during log, and
time spent in, above and below target heart rate zone.
To view and use the Altimeter function:
Check the Mode Indicator arrow. If the mode arrow is not on ALTI, PRESS the [Mode] button until the arrow is
directly below ALTI.
In the ALTIMETER mode (Fig. 21):
• Field 1 displays the vertical ascent or descent rate;