Setting The Altimeter - Suunto ADVIZOR Manuel D'instructions

4.1 SETTING THE ALTIMETER

In setting the Altimeter, there are three processes that can be performed: the Reference Altitude (known altitude
at the current location); Altitude Alarm (signals the user when a certain altitude, programmed, is reached); and
Logbook Recording Interval (allows the user to view the altitude, average rate of vertical movement and heart
rate within a chosen interval of time).
1. PRESS the [Select] button and hold in for 2 seconds. Located in Field 1 is the text “RE” (indicating reference
altitude), located in Field 2, the current altitude will begin to flash (Fig. 22).
2. PRESS the [+] button to scroll the altitude upward or PRESS the [-] button to scroll the altitude downwards.
3. At the desired reference altitude, either PRESS the [Mode] button to accept the changes and return to the
main mode or PRESS the [Select] button to move to the next setting. Located in Field 1, the “ON” or “OFF”
will begin to flash (Fig. 23).
4. PRESS either the [+] or the [-] button to toggle between the “ON” and “OFF” for the Altitude Alarm.
5. At the desired setting, PRESS the [Select] button to move to the next setting. Located in the center of Field
2, the alarm altitude will begin to flash.
6. PRESS the [+] button to scroll the altitude upward or PRESS the [-] button to scroll the altitude downwards.
7. At the desired altitude, either PRESS the [Mode] button to accept the changes and return to the main mode
or PRESS the [Select] button to move to the next setting. Located in Field 1, the text INT and located in Field
2 the time interval will begin to flash (Fig. 24).
8. PRESS either the [+] or the [-] button to scroll through the intervals. There are four time intervals: 20 seconds,
1 minute, 10 minute or 60 minutes.
Recommended interval to use:
A C T I V I T Y
S k i i n g
B i k i n g
H i k i n g
M o u n t a i n e e r i n g
I N T E R VA L
2 0 s e c o r 1 m i n u t e
2 0 s e c o r 1 m i n u t e
1 0 m i n u t e
1 0 m i n u t e o r 6 0 m i n u t e