Stopwatch Sub Mode - Suunto ADVIZOR Manuel D'instructions

Limits “On” means that the Wristop Computer will audibly alert the user that a chosen upper or lower limit has
been exceeded. Limits “OFF” means that the Wristop Computer will not alert the user, but the limits will however
be used to calculate time spent in, above and below the target heart rate zone.
The outer circumference will graphically show the heart rate level reached by the user, in relation to the heart
rate limit set. The circumference will adjust to equal any limit settings starting from the 12 o’clock position going
clockwise. E.g. if the upper limit is set to 140 beats/minute and the lower limit to 130 beats/minute, one full circle
on the outer circumference will equal 10 beats/minute.

2.7 STOPWATCH SUB MODE

The Wristop Computer stopwatch feature can provide split time measurement up to 23 hours 59 minutes and
59 seconds up to 30 split times and heart rate readings can be stored into the HRM memory.
In the HRM mode, PRESS the [Select] button once to enter this submode.
In the Stopwatch mode (Fig. 4):
• Field 1 displays the seconds and tenths of a second,
• Field 2 displays the current heart rate, and
• Field 3 displays hours and minutes and to the far right “stopwatch”.
Note: When the transmitter is not worn, Field 2 displays the current time.
The HRM memory for one event is automatically activated when starting the stopwatch (or countdown timer).
The memory stores total training time, maximum, minimum and average heart rate during training, as well as
time spent in, above and below the target heart rate zone for one event. The next time the stopwatch (or
countdown timer) is activated, the previous event’s information will be erased.
There are three timing modes the user can employ:
• an elapsed time measurement;
• a split time measurement; and
• a finish time measurement for up to 30 runners.