Routine Maintenance - Everflo EF 1200 Instructions Pour L'assemblage

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

WARNING

• Once the motor pump and the machine in which it is integrated have cooled down, be careful:

- not to leave them unattended in the presence of children, elderly people or disabled persons without

supervision;

- to arrange them in a stable position without any risk of falling;

- not to put them in contact or in the immediate vicinity of inflammable materials.

WARNING

• Read the

reCAutions ConCerning pumped ChemiCAl produCts

• All cleaning jobs must only be performed after carrying out the operations described in the

meaning without any moving parts, no pipe full of liquid under pressure and only after complete

cooling.

In particular, always remember to disconnect the power supply.

• Any cleaning jobs must be performed in conditions of total stability.

• To clean, do not use thinners or solvents.

CAUTION

• Before proceeding to clean and decommission the motor pump, remember to run it for a few minutes

with clean water so as to clean the ducts and internal parts and remove the chemical products used.

• Do not leave the motor pump stopped with chemical products inside.

• The motor pump must be protected against freezing.

In very cold environments, to prevent the ice from forming inside, before decommissioning, it is best

to suction a car anti-freeze product and then proceed to fully expel it. If it is not possible to protect the

motor pump this way, before starting it, take it to a warm environment for long enough to melt any ice

inside. Failure to do so could cause serious damage to the motor pump.

WARNING

• The rinsing fluids and the antifreeze liquid must be suitably disposed of and not discarded in the environment.

WARNING

• Follow the maintenance instructions contained in the manual of the machine in which the motor

pump is integrated.

• All maintenance jobs must only be performed after carrying out the operations described in the

paragraph, meaning without any moving parts, no pipe full of liquid under pressure and only after

complete cooling.

In particular, remember to always disconnect the power supply.

• Any maintenance jobs must be performed in conditions of total stability.

• WARNING. To ensure the safety of the motor pump, only use original spare parts supplied by the Manufacturer

or approved by it.

Perform the routine maintenance jobs shown in the manual of the machine in which the motor pump

is integrated; unless otherwise indicated, in relation to the motor pump, remember the following.

CLEANING AND DECOMMISSIONING

MAINTENANCE