Program Your Opener And Remote / The Wireless Push Button/ / Wireless Keypad (Optional); Program The Myq Remote Led Light - LiftMaster LM3800W Mode D'emploi

25 Program Your Opener And Remote / The Wireless Push Button/ / Wireless Keypad
(Optional)
Activate the opener only when door is in full view, free of obstruction and properly adjusted. No one should enter or leave garage while
door is in motion. Do not allow children to operate push button(s) or remote(s). Do not allow children to play near the door. Your garage
door opener receiver and one of the buttons remote control are pre-programmed. If you purchase additional remote controls, the garage door opener
must be programmed to accept the new remote code.
PROGRAM THE RECEIVER TO MATCH ADDITIONAL REMOTE CONTROLS:
USING THE YELLOW ROUND BUTTON
1. Press and release the yellow round button (L)on the opener. The learn indicator light will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the button on the hand-held remote that you wish to operate your garage door.
3. Release the button when the opener light blinks once. It has learned the code. Now the opener will operate when the remote control push button
is pressed. If you release the remote control push button before the opener light flashes, the opener has not learned the code.
KEYLESS ENTRY
1. Press and release the yellow round button (L) on the opener. The learn indicator light will glow steadily for 30 seconds.
2. Enter a 4-digit personal identification number (PIN) of your choice on the keyless entry keypad.
3. Then press the ENTER button.
4. The garage door opener lights will flash (or two clicks will be heard) when the code has been programmed. Repeat the steps above for program-
ming additional remote controls or keyless entry devices. If programming is unsuccessful, program the remote using the learn button.
TO ERASE ALL REMOTE CONTROL CODES
To deactivate any unwanted remote, first erase all codes: Press and hold the yellow round button on opener until the learn indicator light
goes out (approximately 10 seconds). All previous codes are now erased. Reprogram each remote or keyless entry you wish to use.
26

Program the MyQ Remote LED Light

Your garage door opener remote light has already been programmed at the factory to operate with your opener. Any additional or replace-
ment remote lights will need to be programmed.
PROGRAM A DOOR OPENER TO THE MYQ REMOTE LED LIGHT:
1. Press the LEARN button (L) on the light until the green LED comes ON.
2. Press the LEARN button (L) on the door opener.
3. The code has been programmed when the remote light blinks once.
PROGRAM A REMOTE CONTROL TO THE MYQ REMOTE LED LIGHT
1. Press the LEARN button (L) on the light until the green LED comes ON.
2. Press the button on the remote control that you wish to operate the light.
3. The code has been programmed when the remote light blinks once.
To program the light with other accessories, refer to the manual for your accessory.
ADD THE MYQ REMOTE LED LIGHT TO MYQ ACCOUNT
1. Press the LEARN button (L) on the light until the green LED comes ON.
2. Login to the MyQ app and add the MyQ Remote LED Light.
TO ERASE ALL PROGRAMMING FROM THE MYQ REMOTE LED LIGHT
1. Press and hold the LEARN button (L) until the LED turns off (6-10 seconds). All programming is now erased.
14 / en