Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Safety Devices
Casing overheat protection
Electric overload system (Fuse)
Tip-over switch
Mixer overheat protection
Operation
Gas Cylinder Installation
POINT:
• The installation must conform with local codes or, in the absence of local codes, with the Standards for
the Storage and Handling of Liquefied Petroleum Gases, ANSI/NFPA 58 and the Natural Gas and Propane
Installation Code, CSA B149.1.
• Regulator must be installed at outlet of cylinder of propane gas and input gas pressure have to be 11" w.c.
Hose Connection
• All hose connections must be made using a wrench to tighten the fitting.
• Be sure that the cylinder valve is closed when connecting or disconnecting the cylinder.
• Use the hose provided by the manufacturer as an accessory.
Hose to Heater
Propane Tank
Prevent gas leakage by covering with a sealing tape, etc. when connecting the hose and coupler.
Description of Safety Devices
Automatically extinguishes the flame if the heater overheats.
Operating condition: Misfire lamp lights and the post purge sequence runs for
This shuts off the power supply in case of excessive electric current due to
problems with the devices.
Operating condition: The entire operation stops.
Automatically extinguishes the flame when motion or an impact is detected
during operation.
Operating condition: Misfire lamp lights and the post purge sequence runs for
Automatically extinguishes the flame if the heater overheats.
Operating condition: Misfire lamp lights and the post purge sequence runs for
Propane Supply Valve
Connect the hose to the coupler (accessories), and connect the
coupler to the nipple on the main body.
Regulator
about 5 minutes if the heater is in operation.
about 5 minutes if the heater is in operation.
about 5 minutes if the heater is in operation.
10
Publicité
Chapitres
Table des Matières
