Shizuoka Seiki Co. VAL6 GN5 Manuel D'instructions page 12

Safety Information
Arrange for the
cylinder supply
system
Be sure to shut
off the gas supply
when not using
heater
Be sure to
disconnect the
cylinder and
heater when not
using heater
Adjusting an
air intake is
prohibited
Use burner grip
when adjusting
angle of heater
7
The cylinder supply system should be arranged for in order provide vapor
withdrawal from the operating cylinder.
The gas should be turned off at gas supply cylinder/line when the heater is not
in use.
If the heater is to be stored indoors, the connection between the propane
supply cylinder and the heater must be disconnected, and the cylinder
removed from the heater and stored in accordance with Standards for the
Storage and Handling of Liquefied Petroleum Gases, ANSI/NFPA 58 and
Natural Gas and Propane Installation Code, CSA B149.1.
Never touch or adjust an air intake of burner fan motor because the amount
of air intake for the heater is sensitive. Doing so may cause trouble in the
heater.
To avoid major burn injury, be sure to take hold of the burner grip when
setting the angle of the main unit.