Ac6000 Display Lcd Display Icons; Default Screen - Enconnex AC6000 Mode D'emploi

If the Read-Only user is the intended trap receiver:
i. Set the Read-Only Message Process Model OID .1.3.6.1.4.1.52251.2.1.1.4.9 to 3.
ii. Set the Read-Only Security Model OID .1.3.6.1.4.1.52251.2.1.1.4.11 to 3.
iii. Set the Admin Message Process Model OID .1.3.6.1.4.1.52251.2.1.1.4.10 to 0 (for v1) or 1 (for
v2).
iv. Set the Admin Security Model OID .1.3.6.1.4.1.52251.2.1.1.4.12 to 0 (for v1) or 1 (for v2).
Up to 4 trap receivers can be configured. For IPv4, the trap table is at OID
.1.3.6.1.4.1.52251.2.1.1.2.10. For IPv6, the trap table is at .1.3.6.1.4.1.52251.2.1.1.3.10.
Step 1:​ For receiver 0, set the receiver's IP address at TRAP_TABLE.1.3.0.
Step 2:​ Set the receivers community access (public or private) at TRAP_TABLE.1.4.0
Step 3: ​ Enable the receiver by setting the enabled field at TRAP_TABLE.1.2.0 to 1.
For additional configuration, please contact support@enconnex.com.
6. AC6000 Display
6.1 LCD Display Icons
The AC6000 front panel displays system information about its operational state (see Table
6.1-1 for more detail)
6.2

Default Screen

The Default screen displays when there are no system faults or alerts. This screen consists of
the Enconnex Logo, battery status, system mode, and status indicators.
Battery Status - animates when the battery is charging or indicates the battery charge
●
level.
AC-plug icon - Indicates the unit has a valid AC voltage and frequency.
●
Initialization - The power icon blinks until the unit is initialized. Steady indicates normal
●
operation.
UPS Mode - A sine wave icon indicates the system is in UPS Mode.
●
33