Citizen CT-E651 Mode D'emploi page 66

 Label media
C
G
Symbol
A
B
C
D
E
F
G
Label paper thickness
Backing paper thickness
Core inner diameter d (mm)
Core outer diameter D (mm)
CAUTION
 When using the auto cutter, this may damage the cutter lock or the cutter, so be careful of the
following.
· Keep the paper cut length to 29 mm or more.
· Set the cut position to cut between the labels (the backing paper section). Do not cut the
label paper (the tack paper).
 If you have changed the label backing paper type, be sure to adjust the paper sensors again.
 Keep both the left and right margins of the paper to at least 2 mm.
 Keep the top and bottom margins of the paper to at least 1 mm.
A
B
Cut position
Paper feeding
direction
Backing paper width
Label width
Label position on left edge
Label gap
Label length
Label pitch
Label paper angle (R)
65 to 85 μm
60 μm or less
25.4
32
—
D
E F
Item
57.5/79.5 ±0.5
53.5/75.5 ±0.5
2 ±0.5
4 to 30
25 to 300
D + E
3 or less
66
—
Printing surface
(Unit: mm)
Dimensions