Citizen CT-E651 Mode D'emploi page 31

CAUTION
This function is enabled when shipped from the factory. (MSW13-6)
Auto reconnection can take some time to connect when the host is not an iOS device.
 Even if the partner device is an iOS device, the conditions below can interfere with the auto
reconnection function.
Ÿ When you want Bluetooth communication to cut off after printing is complete
Ÿ When there are multiple iOS devices printing on the same printer
Under such conditions, disable auto reconnection.
Enabling and disabling auto reconnect
During self test, press the FEED button 3 times -> Auto reconnect = Valid
During self test, press the FEED button 4 times -> Auto reconnect = Invalid
At the end of self test, new setting will be printed as Auto reconnect [Valid] or [Invalid].
31
— —
Refer to 4.3 Self Test