Functional Description; Intended Use; Product Features - Bosch GSR 10,8 V-LI-2 Professional Notice Originale

Hold power tool by the insulated gripping
surfaces, when performing an operation
where the cutting tool may run into hidden
wiring. Contact with a "live" wire will make
exposed metal parts of the tool "live" and
shock the operator.
Hold the machine with a firm grip. High re-
action torque can briefly occur while driving
in and loosening screws.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
Keep your workplace clean. Blends of mate-
rials are particularly dangerous. Dust from
light alloys can burn or explode.
Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
Avoid unintentional switching on. Ensure
the On/Off switch is in the off position be-
fore inserting battery pack. Carrying the
power tool with your finger on the On/Off
switch or inserting the battery pack into
power tools that have the switch on invites
accidents.
Do not open the battery. Danger of short-
circuiting.
Protect the battery against heat, e. g., al-
so against continuous sun irradiation
and fire. There is danger of explosion.
In case of damage and improper use of the
battery, vapours may be emitted. Provide
for fresh air and seek medical help in case
of complaints. The vapours can irritate the
respiratory system.
When the battery is defective, liquid can es-
cape and come into contact with adjacent
components. Check any parts concerned.
Clean such parts or replace them, if required.
Use the battery only in conjunction with
your Bosch power tool. This measure alone
protects the battery against dangerous over-
load.
Bosch Power Tools

Functional Description

Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.

Intended Use

The machine is intended for driving in and loos-
ening screws as well as for drilling in wood, met-
al, ceramic and plastic.

Product Features

The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Keyless chuck
2 Torque presetting ring
3 Gear selector
4 Battery unlocking button
5 Battery*
6 Rotational direction switch
7 On/Off switch
8 "Power Light"
9 Universal bit holder*
10 Screwdriver bit*
11 Securing screw for keyless chuck
12 Allen key*
*The accessories illustrated or described are not in-
cluded as standard delivery.
English | 17
2 609 140 560 | (13.5.08)