Mixer (Mix); Th Hold - GM Racing 94004 Manuel D'utilisation

EN -- the start or close switch of this function. Select "ON" to start the function, and "OFF" to
close the function.

5.12. MIXER (MIX)

This function allow custom to apply mixing between the steering, throttle, and channel
3 channels.There are main channel and sub-channel in the MIX selection. The servo
travel value of the sub channel is changed along with the change of the main channel
according to the setting rate.
1. Press "ENTER" to see FUNCTION MENU
2. Use the +/- Keys to select the BR_MIX function and press ENTER.
3. Press ENTER to select a item.
4. Firstly main channel setting. Select channel No. (ST, TH, AUX) by "+" or "-". L and R sepa-
rately correspond to the rate of Left and Right servos of the main channel mix
5. Secondly sub channel setting. Select channel No. (ST, TH, AUX) by "+" or "-". L and R
separately correspond to the rate of Left and Right servos selected in the sub
channel.
6. Third Press ENTER to select EN item. Use +/- to select "ON" to enable the function,
and "OFF" to disable the function.
7. Press EXIT twice to save and return to FUNCTION MENU, press EXIT again to
return to the Main Screen.
Exemple:
ST L 50% R 30%
TH L 20% R 50%
EN „ON"

5.13. TH HOLD

This function allows the Throttle Servo to be set to a percentage of the total travel
range. This is an alternative to using the motors choke when starting up the model. Throttle
hold can be performed by pressing the switch to stop the engine. It can be performed
for accident braking. When pressing the switch, throttle trigger doesn't work until the switch
is pressed again.
1. Press "ENTER" to see FUNCTION MENU
2. Use the +/- Keys to select the TH HOLD function and press ENTER.
94004 GM-Racing XG-6i 2.0 FHSS Race Spec
If throttle servo is 60% on the right and rudder servo is 50% on the right,
and then after setting, throttle servo is: 50*30%+60%*50%=45%. Thrott-
le servo will act along with the action of STEERING servo.
34