Operating The Remote Control; Menu-Functions; End Point Adjustment (Epa) - GM Racing 94004 Manuel D'utilisation

4. OPERATING THE REMOTE CONTROL

• Run your car never with low transmitter or receiver batteries.
• If the low battery alarm on the transmitter starts, stop running your model and change or
recharge batteries!
• Never forget switch off the radio after running your vehicle , otherwise the batteries do
not last long.
• Turn on the transmitter fi rst, then the vehicle.
• After driving fi rst turn off the vehicle, then the transmitter.
• For optimal use fi rst check the steering and throttle trim positions.
5. MENU-FUNCTION
Voltage
Model name
Timer
Steering Trim
Throttle Trim

5.1. END POINT ADJUSTMENT (EPA)

Use this when performing left and right steering angle adjustments, throttle high side/
brake side operation amount adjustment, and channel 3 servo up side/down side operati-
on amount adjustment during linkage. EPA adjusting value range: 0~120 %, default is
100%
1. Press "ENTER" in the power on interface and enter function menu. Press "+" or "-"
to choose "EPA". And press "ENTER" and enter EPA adjusting interface.
2. Press "ENTER" to choose each adjusting item, and then press "+" to increase and "-"
to decrease the value of the corresponding item.
3. Press "EXIT" to save your setting and leave EPA interface, and back to the function menu
interface.
TERMS:
F-FORWARD,B-BACK,ST-STEERING, TH-THROTTLE,AUX-AUXILLIARY
94004 GM-Racing XG-6i 2.0 FHSS Race Spec
Steering
Dual Rate
Main menu
Throttle Hold
Modulation
Submenu
26