Exponential Function Steering (St Curv) - GM Racing 94004 Manuel D'utilisation

5.5. EXPONENTIAL FUNCTION STEERING (ST CURV)

This function is used to change the sensitivity of the steering servo around the neutral position.
It has no effect on the maximum servo travel. Note: When the setting is not determined, or
the characteristics of the model are unknown, start with 0% ( when EXP is set to 0%, servo
movement is linear).
1. Press "ENTER" to see FUNCTION MENU.
2. Use the +/- Keys to select the ST CURV function and press ENTER.
3. Use the +/- Key to change the value.
4. Press EXIT to save and return to FUNCTION MENU, press EXIT again to return to the
Main Screen.
STEERING CURVER adjusting value range: -100%~+100% Default is 0% (Linear)
STEERING EXP ADJUSTMENT
1. When you want to quicken steering operation, use the (+) button to adjust the +
side. When you want to make steering operation milder, use the (-) button to adjust the
-side.
2 . When ending setting, return to the function menu by pressing the (EXIT) button .
TERMS: M-MODE, R--RATE
5.6. THROTTLE CURVE (TH CURV)
This function makes the throttle high side and brake side direction servo operation
quicker or milder. It has no effect on the servo maximum operation amount. For the high side,
selection from among three kinds of curves (EXP/VTR/CUR) is also possible.
Note: When the course conditions are good and there is no sense of torque at the power unit,
set each curve to the + side (quick side). When the road surface is slippery and the
drive wheels do not grip it, set each curve to the - minus (mild) side. Note: Brake side only has
EXP curves.
1. Press "ENTER" to see FUNCTION MENU
2. Use the +/- Keys to select the TH CURV function and press ENTER.
3. Press ENTER to select a setting.
4. Use the +/- Key to change the value.
5. Press EXIT to save and return to FUNCTION MENU, press EXIT again to return to the
Main Screen.
ADJUSTMENT METHOD FOR EXP CURVE
Select EXP at setup item "M", select setup item "R" and make the following adjustments:
1. Forward side adjustment:
Use the (+) button to adjust the + side when you want to quicken the rise and use the (-)
button to adjust the - side when you want to make the rise milder.
2. Brake side adjustment:
Select the setting item „BR" by ENTER button and use the (+) button to adjust the
+ side when you want to quicker the rise and use the (-) button to adjust the - side when
you want to make the rise milder.
3. When ending setting, return to the initial screen by pressing the EXIT.
94004 GM-Racing XG-6i 2.0 FHSS Race Spec 28