Changing Blades - DeWalt DC390 Guide D'utilisation

FIG. 2
CAUTION: Make certain the switch lock-off button (A) is engaged
to prevent switch actuation before removing or installing battery.
To install the battery pack into the tool handle, align the base of
the tool with the notch inside the tool's handle and slide the battery
pack firmly into the handle until you hear the lock snap into place.
To remove the battery pack from the tool, press the release buttons
(M) and firmly pull the battery pack out of the tool handle. Insert it into
the charger as described in the charger manual (Fig. 2).
OPERATION
Switch
Release switch lock-off button (A) by pressing button as shown (Fig. 3).
Pull the trigger switch (B) to turn the motor ON. Releasing the trigger
switch turns the motor OFF. Releasing the trigger switch also auto-
matically actuates lock-off button.
NOTE: This tool has no provision to lock the switch in the ON position,
and should never be locked ON by any other means.

Changing Blades

CAUTION: TURN OFF TOOL AND REMOVE BATTERY PACK
FROM SAW BEFORE CHANGING ACCESSORIES OR MAKING
ANY ADJUSTMENTS.
FIG. 3
A
B
M
TO INSTALL THE BLADE
1. Place inner clamp washer (N) on saw spindle with the large flat
surface facing out toward the blade (Fig. 4).
2. Retract the lower blade guard (G) and place blade on saw spindle
against the inner clamp washer, making sure that the blade will
rotate in the proper direction (the direction of the rotation arrow on
the saw blade and the teeth must point in the same direction as the
direction of rotation arrow on the saw). Do not assume that the
printing on the blade will always be facing you when properly
installed. When retracting the lower blade guard to install the blade,
check the condition and operation of the lower blade guard to
assure that it is working properly. Make sure it moves freely and
does not touch the blade or any other part, in all angles and
depths of cut.
3. Place outer clamp washer (O) on saw spindle with the large flat
surface against the blade with beveled side facing out.
4. Thread blade clamping screw (H) into saw spindle by hand (screw
has left-hand threads and must be turned counterclockwise to
tighten).
L
FIG. 4
K
N
F
O
H
9
G