Introduction; Installation - Fortress Building Products AL13 HOME Instructions D'installation

INTRODUCTION

READ INSTRUCTIONS COMPLETELY BEFORE
STARTING INSTALLATION
It is the responsibility of the installer to meet all code and
safety requirements, and to obtain all required building
permits. The deck and railing installer should determine and
implement appropriate installation techniques for each
installation situation. Fortress Railing Products and its
distributors shall not be held liable for improper or unsafe
installations.
Fortress AL
framing and should never be attached to only the deck
boards.
Note
When cutting Fortress railing, it is very important to complete
the following at cut points:
• Remove all metal shavings from the cut area.
• File any sharp edges left by cutting. Thoroughly wipe and
remove any filings, grime or dirt from the railing.
• Apply two coats of Fortress zinc based touch-up paint to the
cut area. If touch up is at rail ends, allow paint to dry before
connecting bracket to post.
• Be sure to remove any metal shavings from the surface of
deck, patio or balcony to prevent stains on the deck surface.
Torx Safety Tips
• Always use the lowest speed setting on drill.
• To reduce chance of bit breakage, start tightening with drill on
low torque setting and work up until screw is secured.
Tip: Pre-drill holes with 3/16" [4.5mm] drill bit.
AL
HOME posts must always be secured to the deck
13
HOME TRADITIONAL PANEL INSTALLATION
13
3