Publicité
Les langues disponibles
Les langues disponibles
- Pull both sides of the fairing back by slightly removing the stowage bin so as to facilitate the rear fairing's
dismounting. Pull both sides at once : as the taillight is fitted between both covers, this one shall be removed at the
same time (see pictures).
Pull up the bin so as to clear
the edge at the red line level
4. Dismantling of the rear mudguard.
- Remove the hose from its location. Unscrew the 3 rear mudguard's fitting screws. Remove the mudguard. Attach
the hose to the original cable holder thanks to provided plastic ring (see photo).
Caution. Do not tighten completely the ring. The goal is to keep the hose : excessive tightening
Hose's location
5. Fitting kit's assembly.
- Prepare the long and the 2 shorts brackets, the 3 threaded fasteners and the 3 fitting screws of the original
mudguard. Mount the threaded fasteners on the brackets as shown on the picture.
- Place the 3 brackets provided with the threaded fasteners as indicated on the pictures. Do not tighten completely :
an adjustment may be to do later.
6. Reassembly.
- Refit the stowage bin (6 screws). Replace the rear fairing and the taillight. Slide the rear seat by pulling it away so
well fit all the clips. Screw again only 6 Phillips screws of 8 (the 2 screws that fit the mudguard are no longer useful)
and screw again the 2 taillight's fitting screws.
- Clip again the petrol tank flap's cover and screw the fitting screw.
- Replace the handles block (4 screws) and connect again the taillight's terminal.
- Replace the seat (2 screws) by connecting the terminals (blue wire on blue mark).
Clips' location : pull in the direction of the arrow
risks to pinch and damage the hose.
Location of the screws securing the mudguard
at the right top to exit the fairing
Hose's fixation with ring
Publicité
