Ermax 7701118 Notice De Montage page 5

Original indicators will be definitively removed with the Ermax undertray.
Fitting kit
Check the kit contents before starting the fitting :
Fitting kit
- 3 BHc screws 5x15 big head
- 1 BHc screws 5x25 small head
- 3 threaded fasteners Ø5
- 5 rubber washers Ø6
Assembly
1. Dismantling of the saddle.
- Open the seat. Unscrew the 2 screws holding the saddle. Dismantle the saddle by taking care not to extract the 2
sensor terminals. Disconnect the terminals.
2. Dismantling of the handle cover and block.
- Unscrew the 2 Phillips screws (arrows on photo on the left) on top of cover, and then unclip the cover.
Think to take blinkers.
Undertray Number plate support
- 2 BHc screws 5x25 big head
- 2 short brackets
- 3 steel washers Ø5
- 2 resistances 25W6Ω8J « Gold series »
Saddle holding screws
View of the fitting system of
the handle cover : large arrow
show clips, small ones the
direction in which the cover has
to be spreaded out to be
unclipped.
FITTING INSTRUCTIONS
« UNDERTRAY »
Honda PCX 125 2010 → ∞
Estimated fitting time : 2 hours
Resistances
- 3 Nylock nuts Ø5
- 1 long bracket
- 1 plastic ring
Tip to unclip the cover : use a
small flat screwdriver to act as
a lever in the direction of the
arrow, while taking care to
protect the cover.