KitchenAid KDRS407 Guide D'utilisation Et D'entretien page 11

Before removing or replacing grill, make sure the control knobs
are turned to OFF. Allow the grill to cool completely before
handling.
To Remove:
1. Remove grill grate and wave tray.
2. Pull forward slightly on the flame spreader to release the tabs
from the rear slots and lift out.
A. Grill front
B. Rear tabs and slots
3. Lift up and out to remove the burner assembly.
Remove Grease Trays:
1. To remove the small grease tray, unhook tabs from slots and
lift slightly to disengage it from the large grease tray.
A
B
C
A. Large grease tray
B. Grease tray connection
C. Small grease tray
D. Slots
2. Unhook tabs from slots and lift out the large grease tray.
A
A. Large grease tray
B. Slots
B
A
D
B
3. Remove the drip tray.
A. Drip tray
4. Clean basin. See "General Cleaning" section.
To Replace:
1. Slide drip tray into opening on the right front side of the grill
basin. There are guides to assure correct placement of the
drip tray.
A. Drip tray
2. Insert the large grease tray all the way under the back edge of
the grill basin and hook it into the slots.
A
A. Large grease tray
B. Slots
3. Insert the small grease tray all the way under the front of the
grill basin and hook it into the slots.
When the 2 grease trays are installed properly, the small
grease tray will hook over the large grease tray.
A
B
C
A. Large grease tray
B. Grease tray connection
C. Small grease tray
D. Slots
A
A
B
D
11