Starting/Stopping Instructions - Troy-Bilt TB415CS Manuel De L'utilisateur

WARNING:
Operate this unit only in a well-ventilated
outdoor area. Carbon monoxide exhaust fumes can be
lethal in a confined area.
WARNING:
Avoid accidental starting. Make sure you
are in the starting position when pulling the starter rope
(Fig. 10). To avoid serious injury, the operator and unit
must be in a stable position while starting.
Make sure that any Add-On item is installed correctly
and secure before starting the unit.
STARTING INSTRUCTIONS
1. Check the oil level in the crankcase. Refer to Checking
the Oil Level.
2. Fill the fuel tank with fresh, clean unleaded gasoline. Refer
to Fueling the Unit.
3. Fully press and release the primer bulb 10 times, slowly.
Some amount of fuel should be visible in the primer bulb
and fuel lines (Fig. 9). If you can't see fuel in the bulb,
press and release the bulb as many times as it takes
before you can see fuel in it.
4. Place the choke lever in Position 1 (Fig. 9).
5. Crouch in the starting position (Fig. 10), squeeze the
throttle control, and pull the starter rope briskly 5 times.
6. Place the choke lever in Position 2 (Fig. 11A).
7. While squeezing the throttle control, pull the starter rope
briskly 1 to 4 times to start the engine.
8. Keep the throttle squeezed and allow the engine to warm
up for 15 to 30 seconds.
9. Place the choke lever in Position 3 (Fig. 11B). The unit is
ready for use.
IF... the engine does not start, go back to step 3.
IF... the engine fails to start after a few attempts, place the
choke lever in Position 3 and squeeze the throttle
control. Pull the starter rope briskly 3 to 8 times. The
engine should start. If not, repeat.
IF WARM... If the engine is already warm, start the unit with
the choke lever in Position 2. After the unit starts, move
the choke lever to Position 3.
STOPPING INSTRUCTIONS
1. Release your hand from the throttle control. Allow the engine to
cool down by idling.
2. Press the On/Off Stop Control switch in the OFF (O) position
and hold until the engine comes to a complete stop (Fig. 12).
STARTING AND STOPPING INSTRUCTIONS
7
Starter Rope
Throttle Control
Position 2
Fig. 11A
Stop/Off (O)
Throttle Control
Choke Lever
Position 1
Primer Bulb
Fig. 9
Fig. 10
Position 3
Fig. 11B
Start/On (I)
Fig. 12