Accessories; Ec Declaration Of Conformity - Black & Decker KD1010 K Mode D'emploi

To switch the tool on, press the on/off switch (1).
u
To switch the tool off, release the on/off switch.
u
Brush monitor (fig. E)
Your tool has a built in system that monitors the health of the
brushes.
Green brush monitor indicator (17). The brushes are in
u
good condition.
Red brush monitor indicator (18). The brushes are warn
u
and need replacing, return your tool to an authorised
BLACK+DECKER Service Centre in order to to have the
brushes replaced.

Accessories

The performance of your tool depends on the accessory used.
BLACK+DECKER and Piranha accessories are engineered to
high quality standards and designed to enhance the
performance of your tool. By using these accessories you will
get the very best from your tool.
Maintenance
Your BLACK+DECKER corded/cordless appliance/tool has
been designed to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Warning! Before performing any maintenance on corded/
cordless power tools:
Switch off and unplug the appliance/tool.
u
Regularly clean the ventilation slots in your appliance/tool/
u
charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth. Do
u
not use any abrasive or solvent-based cleaner.
Regularly open the chuck and tap it to remove any dust
u
from the interior (when fitted).
Mains plug replacement (U.K. & Ireland only)
If a new mains plug needs to be fitted:
Safely dispose of the old plug.
u
Connect the brown lead to the live terminal in the new
u
plug.
Connect the blue lead to the neutral terminal.
u
Warning! No connection is to be made to the earth terminal.
Follow the fitting instructions supplied with good quality plugs.
Recommended fuse: 5 A.
Protecting the environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions.
(Original instructions)
Further information is available at www.2helpU.com
Technical data
Input voltage V
AC
Power input W
No-load speed min
-1
Impact rate min
-1
Impact energy per
stroke according to j
EPTA-Procedure 05/2009
Weight
kg
Max. drilling capacity
Concrete
mm
Steel
mm
Wood
mm
Level of sound pressure according to EN 60745:
Sound pressure (L ) 93 dB(A), uncertainty (K) 3 dB(A)
pA
Sound power (L ) 104 dB(A), uncertainty (K) 3 dB(A)
WA
Vibration total values (triax vector sum) according to EN 60745:
Impact drilling into concrete (a
Chiselling (a ) 13,6 m/s
h, Cheq

EC declaration of conformity

MACHINERY DIRECTIVE
KD1010 K Impact Drill
Black & Decker declares that these products described under
"technical data" are in compliance with:
EN60745-1:2009+A11:2010, EN60745-2-6:2010.
These products also comply with directive 2014/30/EU,
2006/42/EC and 2011/65/EU.
For more information, please contact Black & Decker at the
following address or refer to the back of the manual.
ENGLISH
KD1010 K
0 - 4100
2 2
) 14,2 m/s , uncertainty (K) 1,5 m/s
h, ID
2 2
, uncertainty (K) 1,5 m/s
230
1000
0 - 850
3
5.4
32
13
40
7