Troubleshooting; Technical Data; Warranty - GreenWorks G48LM41 Manuel Opérateur

6

TROUBLESHOOTING

Problem Possible cause
The handle is The bolts are not
not in position. engaged correct-
ly.
The machine The battery ca-
does not start. pacity is low.
The bail switch is
defective.
The battery key
is not put in.
The machine The lawn is
cuts grass un- rough.
evenly.
The blade height
is not set cor-
rectly.
The machine Wet grass clip-
does not mulch pings attach to
correctly. the deck.
The mulch plug
is missing.
The machine is The grass is too
hard to push. tall, or the blade
height is too low.
The grass catch-
er and the blade
drags in thick
grass.
There is a high The blade is un-
vibration in the balanced and
machine. worn.
The engine shaft
is bent.
English
Problem
The machine
Solution
stops during
Adjust the height mowing.
of the handle
and make sure
that the knobs
and bolts are
aligned correctly.
Charge the bat-
tery pack.
Replace the bail
switch.
Put in the battery
key.
* If you cannot find the solution to these problems, go to
the service center.
Examine the
mowing area.
7
Move the wheels
to a higher posi-
Voltage
tion.
No load speed
Wait until the
grass dries be-
Cut width
fore mowing.
Cut height
Install the mulch
Grass catcher capacity
plug.
Weight (without battery
Increase the
pack)
blade height.
Measured sound pressure
level
Empty the grass
clippings from
Guaranteed sound power
the grass catch-
level
er.
Vibration
Replace the
Battery model
blade.
Charger model
1. Stop the en-
gine.
2. Remove the
Double-insulated con-
safety key
struction
and battery
pack.
IPX
3. Disconnect
the power
8
source.
4. Inspect for
(The full warranty terms and conditions can be found on
damage.
Greenworks webpage)
5. Repair the
The Greenworks warranty is 3 years on the product,
machine be-
and 2 years on batteries (consumer/private usage) from
fore you start
the date of purchase. This warranty covers
it again.
manufacturing faults. A faulty product under warranty
might be either repaired or replaced. A unit that has
been misused or used in other ways then described in
7
Possible cause
The blade height
is too low.
The battery pack
is out of power.
The grass clip-
pings attach to
the deck or the
blade.
Operation tem-
perature of the
machine is too
high.

TECHNICAL DATA

48 V
3600 / min
410 mm
25 - 80 mm
50 L
41.4 lbs 18,8 kg
L = 68 dB(A) , K = 2.7
PA
dB(A)
L
WA.d
＜ 2.5 m/s
G4824B4 and other BAM
series
G4824C4 and other CAM
series
IPX4

WARRANTY

EN
Solution
Increase the
blade height.
Charge the bat-
tery pack.
Remove the bat-
tery pack and
check the deck.
Cool the ma-
chine.
= 91 dB(A)
2 2
, K = 1.5 m/s