Jacuzzi Luxury Serie Mode D'emploi page 94

Controlling Whirlpool Action
The whirlpool action in your bath is infl uenced by three factors – direction of fl ow, force of water, and force of air. All baths manu-
factured by Jacuzzi Whirlpool Bath© are equipped with fully adjustable PowerPro® jets, which are adjustable for all three factors.
Some baths have additional directionally adjustable jets which can be adjusted for direction and fl ow of air only.
Direction: To change the direction of the water fl ow, swivel the jet nozzle to the desired angle. The jets can be directed indi-
vidually toward any location on your body to provide a hydromassage. The jets can also be adjusted so that they all point in
the same direction (clockwise or counterclockwise) to circulate the water in a circular motion around the bath, causing a total
whirlpool effect.
Water Force: The high volume, fully adjustable jets can be adjusted to control the force of the water coming into the bath. For
robust action, increase the force of the fl ow by rotating the jet handles to the left (counterclockwise). For a more gentle effect,
rotate the handles to the right (clockwise). Never run the whirlpool system with all the jets closed.
Force of Air: Two knobs located on the bath serve as controls for the air induction system. The intensity of the hydromassage
whirlpool action is determined by the amount of air inducted into the water. As the amount of air is increased, the hydromassage
action increases. For maximum air induction, rotate the control knobs fully counterclockwise to the largest circles. For fewer air
bubbles, decrease the amount of air induction by rotating the control knob clockwise. When the knobs are turned to the smallest
circles, only water is being circulated.
AIR INDUCTION CONTROLS
TURN CLOCKWISE TO
REDUCE AIR FLOW
Magic Touch® Whirlpool Switch
The Magic Touch whirlpool ON/OFF switch, conveniently located on the bath, allows you to turn the whirlpool system on and off
while in the bath. Simply push down on the switch button to turn on the whirlpool system. To turn the system off, push down on
the button again.
If your bath has an optional Jacuzzi Whirlpool Bath© wall mounted timer, set it for the amount of time you wish the whirlpool to
operate. NOTE: when you desire less than 10 minutes of whirlpool action, it is necessary to turn the timer knob clockwise past
the number 10 and then back to the desired amount. If the whirlpool action does not begin when the timer is correctly set, it is
necessary to push the Magic Touch switch button.
Printed on Recycled Paper
Page 4
TURN COUNTER-CLOCKWISE
TO INCREASE AIR FLOW
MAGIC TOUCH SWITCH
DEPRESS CENTER ON/OFF
JETS
DIRECTIONALLY
ADJUSTABLE
FULLY
ADJUSTABLE
Printed in the U.S.A.
©2006 ER28000 06/06