Error Indications On The Front Display - Yamaha MusicCast R-N602 Mode D'emploi

Error indications on the front display

Message
Access to the PC is denied.
Access denied
The unit cannot access the USB device.
Access error
The unit cannot access the iPod.
The connected iPod is not supported by
the unit.
There is a problem with the signal path
from the network to the unit.
The speaker cables short circuit.
Check SP Wires
There are no playable files in the selected
No content
folder.
The unit is preparing for connecting to the
Please wait
network.
The unit cannot play back the songs stored
Unable to play
on the iPod for some reason.
The unit cannot play back the songs stored
on the PC for some reason.
Firmware update is failed.
Version error
Cause
Configure the sharing settings and select the unit as a device to
which music contents are shared (p. 30).
Turn off the unit and reconnect your USB device. If the problem
persists, try another USB device.
Turn off the iPod and turn it on again.
Use an iPod supported by the unit (p. 39).
Make sure your router and modem are turned on.
Check the connection between the unit and your router (or hub)
(p. 14).
Twist the bare wires of the cables firmly and connect to the unit
and speakers properly.
Select a folder that contains files supported by the unit.
Wait until the message disappears. If the message stays more than
3 minutes, turn off the unit and turn it on again.
Check the song data. If it cannot be played on the iPod itself, the
song data or storage area may be defective.
Check if the format of files you are trying to play is supported by
the unit. For information about the formats supported by the unit,
see "Playing back music stored on media servers (PCs/NAS)" (p.
30). If the unit supports the file format, but still cannot play back
any files, the network may be overloaded with heavy traffic.
Update the firmware again.
Remedy
57
En