Power Outage - Gigaset 5040 Mode D'emploi

FCC / ACTA Information
Warning:
Changes or modifications to this unit not expressly
approved by Gigaset Communications USA LLC could void the
FCC authority to operate the equipment. This includes the
addition of any external antenna device.
This equipment complies with Part 68 of the FCC rules and the
requirements adopted by the ACTA. On the bottom of the base
station is a label that contains, among other information,
a product identifier in the format US:AAAEQ##TXXXX. If
requested, this number must be provided to the telephone
company.
A plug and jack used to connect this equipment to the pre-
mises wiring and telephone network must comply with the
applicable FCC Part 68 rules and requirements adopted by the
ACTA. A compliant telephone cord and modular plug is pro-
vided with this product. It is designed to be connected to a
compatible modular jack that is also compliant. See installation
instructions for details.
The REN is used to determine the number of devices that may
be connected to a telephone line. Excessive RENs on a tele-
phone line may result in the devices not ringing in response to
an incoming call. In most but not all areas, the sum of RENs
should not exceed five (5.0). To be certain of the number of
devices that may be connected to a line, as determined by the
total RENs, contact the local telephone company. For products
approved after July 23, 2001, the REN for this product is part of
the product identifier that has the format US:AAAEQ##TXXXX.
The digits represented by ## are the REN without a decimal
point (e.g., 03 is a REN of 0.3). For earlier products, the REN is
separately shown on the label.
A copy of the supplier's Declaration of Conformity (SDoC) is
available at this Internet address: www.gigaset.com/docs.
If this equipment causes harm to the telephone network, the
telephone company will notify you in advance, that temporary
discontinuance of service may be required. But if advance
notice isn't practical, the telephone company will notify the
customer as soon as possible. Also, you will be advised of your
right to file a complaint with the FCC if you believe it is
necessary.
The telephone company may make changes in its facilities,
equipment, operations or procedures that could affect the
operation of the equipment. If this happens the telephone
company will provide advance notice in order for you to make
necessary modifications to maintain uninterrupted service. If
you experience trouble with this telephone system, disconnect
it from the network until the problem has been corrected or
until you are sure that the equipment is not malfunctioning.
If trouble is experienced with this equipment, for repair or war-
ranty information, please contact Support at 1-866-247-8758. If
the equipment is causing harm to the telephone network, the
telephone company may request that you disconnect the
equipment until the problem is resolved. This equipment is of
a type that is not intended to be repaired by the Customer
(user).
14
en
This telephone system may not be used on coin service pro-
vided by the telephone company. Connection to party line ser-
vice is subject to state tariffs. Contact the state public utility
commission, public service commission or corporation com-
mission for information. Privacy of communications may not be
ensured when using this phone.
If your home has specially wired alarm equipment connected
to the telephone line, ensure the installation of this equipment
does not disable your alarm equipment. If you have questions
about what will disable alarm equipment, consult your tele-
phone company or a qualified installer.
This telephone system equipment has been tested and found
to comply with the limits for Class B digital device, pursuant to
Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interfer-
ence, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation. Some
cordless telephones operate at frequencies that may cause
interference to nearby TV's and VCR's; to minimize or prevent
such interference, the system base should not be placed near
or on top of a TV or VCR; and, if interference is experienced,
moving the base farther away from the TV or VCR will often
reduce or eliminate the interference.
However, there is no guarantee that interference will not occur
in a particular installation. If this telephone system does cause
harmful interference to radio or television reception, which can
be determined by turning the system off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the base station and
receiver.
3. Connect the base station into an outlet on a circuit different
from that to which the receiver is connected.
4. Consult the dealer or an experienced radio TV technician for
help.
Notice for Direct Inward Dialing ("DID")
ALLOWING THIS EQUIPMENT TO BE OPERATED IN SUCH A MAN-
NER AS TO NOT PROVIDE FOR PROPER ANSWER SUPERVISION
IS A VIOLATION OF PART 68 OF THE FCC'S RULES.
Notice to Hearing Aid Wearers:
This phone system is compatible with inductively coupled
hearing aids.

Power Outage:

In the event of a power outage, your cordless telephone will
not operate. The cordless telephone requires electricity for
operation. You should have a telephone that does not require
electricity available for use during power outages.