Frequent Faults & Solutions 13; Product Maintenance - GEARSTONE CS-WP7 Mode D'emploi

Common faults and solutions
If you have other questions, please call local distributors or our company's after-sales
service.
Problem Possible cause
No power connected
Treadmill can't
The power is not turned
work:
The safety lock is not sucked on;
Circuit signal system is open
The fuse is burned out
The running
Insufficient lubrication
belt does not
The running belt is too tight
run smoothly
The running belt is too loose
Running belt
skidding
The belt is too loose
Electronic meter displays error messages and troubleshooting methods:
Problem
Possible cause
Bad communication
E01
Explosion
E02
No sensor signal
E03
Controller or motor
E04
Overload protection
E05
Controller or motor
E06
E07 The safety lock is not sucked
External disturbance.
Abnormal

Product maintenance

Proper maintenance is an impractical way to keep your treadmill in its best condition
forever. Wrong maintenance can damage or shorten the life of the treadmill.
a. Due to wear and damage, frequent inspections are required; worn or damaged
accessories, such as motors, electric controls, power cords, and running belts, have
been repaired or professionally repaired, and their use safety is the same as when they
were shipped.
b. Immediately replace those defective parts or reduce the equipment to be idle until
repaired; (such as power cord)
c. Pay special attention to the most easily worn components; (such as running belts)
d. If the power cord is damaged, in order to avoid danger, it must be replaced by
professional personnel from the manufacturer, its maintenance department or similar
departments.
Frequent Faults & Solutions 13
Repair method
Plug into socket
put the power switch "ON"
The safety lock is sucked into the lock
Check the controller input and signal
Replace the fuse
Add methyl silicone oil lubricant
Adjust the running belt tightness
Adjust the running belt tightness
Adjust the belt tensiontightness
Repair method
The signal line is not plugged in properly, plug it in again
The power tube has broken down, replace the electric control
The sensor line is not plugged in properly, plug it in again
The load is too heavy, replace the controller and motor
The load is too heavy, replace the electric
The load is too heavy, replace the electric
Sucked into the safety lock
Turn off the power switch, and then turn it
on again after 1 minute.abnormality