Dyna-Glo DGH483CRP Mode D'emploi page 11

CARE AND MAINTENANCE
Burner Assembly
Removing The Burner Assembly
1. Make sure all control knobs are in the OFF
position, gas supply valve is closed, and the
gas hose is disconnected from the gas supply.
2. Open lid and remove warming rack, smoker
box assembly, cooking grates, and heat
tents.
3. Remove hinge pin as illustrated in Figure 1.
4. Slide main burners & sear burner out of firebox.
5. Detach ignition wire from electrode in Figure 2.
Figure 1
Figure 2
25
Warming
Rack
Cooking
Grates
Smoker Box
Assembly
Heat Tents