Makita MLT100 Manuel D'instruction page 7

This tool is provided with the sub table (R) on the right
side of the main table. To use the sub table (R), loosen
two screws on the right side counterclockwise, pull out
the table (R) fully and then tighten the two screws to
secure it.
Sub table (back)
1
2
008768
To use the sub table (back), loosen the screws on the left
and right hand sides under the table and pull it out
backwards to the desired length. At the desired length,
tighten the screw securely.
Slide table
1
2
008767
CAUTION:
After using slide table, be sure to lock it by moving
•
the locking plate to the vertical position.
This tool is provided with the slide table on the left side.
The slide table slides back and forth. Pivot the locking
plates on the back and front sides to the horizontal
position before using it.
Hold workpiece firmly with the miter gauge using a
clamp on the miter gauge and slide the workpiece
together with the slide table at the time of cutting
operation.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
1. Screws
2. Sub table (back)
1. Slide table
2. Locking plate
7
The tool is shipped from the factory with the saw blade
and blade guard not in the installed condition. Assemble
as follows:
Installing or removing saw blade
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before installing or removing the blade.
Use only the Makita socket wrench provided to
•
install or remove the blade. Failure to do so may
result in overtightening or insufficient tightening of
the hex bolt. This could cause an injury.
Use the following saw blade. Do not use saw
•
blades which
characteristics specified in these instructions.
For Model Max. dia. Min. dia. Blade thickness
260 mm 230 mm
MLT100
(10") (9-3/32")
009110
CAUTION:
Check the arbor hole diameter of the blade before
•
installing the blade. Always use the correct ring for
the arbor hole of the blade you intend to use.
1
008769
Remove the table insert on the table. Hold the outer
flange with the wrench and loosen the hex nut
counterclockwise with the wrench. Then remove the
outer flange.
Assemble the inner flange, saw blade, outer flange and
hex nut onto the arbor, making sure that the teeth of the
blade are pointing down at the front of the table. Always
install the hex nut with its recessed side facing the outer
flange.
1
009047
do not comply with
1.8 mm (5/64") 2 mm (3/32")
or less or more
1. Wrench
2
2. Wrench
3. Hex nut
3
1. Inner flange
2
2. Saw blade
3. Outer flange
4. Hex nut
3
4
the
Kerf