Functional Description; Storing Accessories; Adjusting The Bevel Angle - Makita MLT100 Manuel D'instruction

1
17 mm
(11/16")
2
008793
1
008794
Locate the table saw in a well lit and level area where
you can maintain good footing and balance. It should be
installed in an area that leaves enough room to easily
handle the size of your workpieces. The table saw
should be secured with four screws or bolts to the work
bench or table saw stand using the holes provided in the
bottom of the table saw. When securing the table saw on
the work bench, make sure that there is an opening in
the top of the work bench the same size as the opening
in the bottom of the table saw so the sawdust can drop
through.
If during operation there is any tendency for the table
saw to tip over, slide or move, the work bench or table
saw stand should be secured to the floor.

Storing accessories

009025
1. 6 mm (1/4") Std.
washer
2. No.10 wood
screw 40 mm
(1-1/2") min.
length
1. 6 mm (1/4") Std.
washer
2. 6 mm (1/4")
Mounting bolt &
Nut tighten
securely
2
1. Push stick
1
1
008759
Push stick, Triangular rule, blade and wrenches can be
stored on the left side of the base and the rip fence and
miter gauge can be stored at the right side of the base.
The blade guard to be removed in dado cutting can be
stored at the rear.

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Adjusting the depth of cut
009026
The depth of cut may be adjusted by turning the handle.
Turn the handle clockwise to raise the blade or
counterclockwise to lower it.
NOTE:
Use a shallow depth setting when cutting thin
•
materials in order to obtain a cleaner cut.

Adjusting the bevel angle

009027
5
1. Rip fence
(Guide rule)
2. Miter gauge
2
1. Handle
1
1. Arrow pointer
1
2. Lock lever
2