Controls And Functions; Operations; Switching The Unit On And Off; Manual Tare - OHAUS EB Serie Manuel D'instruction

EN-6 EB SERIES
3.2 Controls and Functions (cont.)
•
•
•
•
•
•
•
•

4. OPERATIONS

4.1

Switching the Unit On and Off

The power switch is located underneath the right-hand side of the scale. Push the
switch to the "I" position to turn the scale on, and to the "O" position to turn the scale
off. Allow 15-30 minutes for the scale to warm up before use.
NOTE: Make sure the weighing pan is empty before turning the scale on.
4.2

Manual Tare

A Tare value in memory is indicated by "NET" on the display.
Place the container on the weighing pan (ex. 100g), then press
TARE.
The weight is tared and display will show "0".
To clear the Tare value, press TARE with the pan empty.
Check
M+
Exit
Units
Clear
Zeros the display
Initiates setup of Checkweigh parameters: HI and LO range weight
or piece count values
moves the active digit to the left when setting up parameter
values
Initiates setup of Counting/Sampling parameters
increments the active digit when setting up parameter values
Initiates setup of Percent weighing parameters
moves the active digit to the right when setting up parameter
values
During parts counting, toggles through piece weight and piece
count (in g unit, also displays total weight)
Count
Tare
Enter
%
EB
SERIES
Zero
NET