Overview Of Controls And Indicator Functions - OHAUS CD-11 Manuel D'instruction

CD-11 Indicator

OVERVIEW OF CONTROLS AND INDICATOR FUNCTIONS

1
2
3
4
5
No. No. No. No. No. Designation Designation Designation Designation Designation
1 Display
2 Center of Zero
3 Stable
4 Display Hold
5 ON/ZERO/ Off button
6 Pcs
PRINT/ Units button
7
8 Gross Brutto
9 G/N/T/ Menu button
10 Net
11 TARE button
12 Tare
13 BAT
14 kg
g
15 oz
16 lb
7
6
F u n c t i o n F u n c t i o n F u n c t i o n F u n c t i o n F u n c t i o n
LCD display, indicates weight, modes and setup information.
LCD indicator prompt, indicates center of zero when within +/- 0.25d.
LCD indicator prompt, indicates that the measured value has become stable.
LCD indicator prompt, indicates display hold is active.
Turns Indicator on or off. Secondary use, provides zero function.
LCD indicator prompt, indicates parts counting function is active.
Short press, prints data which is displayed on the Indicator.
Long press, changes unit of measure or mode.
When in menus, each press advances through the menus.
When in submenus or establishing Average Piece Weights, each press
toggles through settings.
LCD indicator prompt, indicates gross weight.
Recalls Gross/Net/Tare. Long press allows entry into menus.
When in menus, accepts the settings.
when in parts counting mode, long press sets up Average Piece Weight.
LCD indicator prompt indicates net weight.
When pressed, enters tare value into memory.
LCD indicator prompt indicates tare weight.
When establishing print interval, increments through the settings.
LCD indicator prompt, indicates low battery.
LCD indicator, when lit, indicates weight in kilograms.
LCD indicator, when lit, indicates weight in grams.
LCD indicator, when lit, indicates weight in ounces.
LCD indicator, when lit, indicates weight in pounds.
9 10
8
EN-3
16
15
14
13
12
11