Connect Power - GE Profile PWS06D Serie Manuel Du Propriétaire Et Instructions D'installation

REMOVE RUBBER PAD AND
2
SHIPPING BRACKET (Cont.)
• Remove 2 screws, shipping bracket, rubber pad
and discard.
Rubber Pad
Shipping
Bracket
Shipping Bracket
Screws
• Re-install Toekick with 3 screws.
Screws
3

CONNECT POWER

• Connect power cord plug to a properly grounded
receptacle.
• Make sure power is on by opening the door to
see if interior light turns on.
49-1000514 Rev. 1
Installation Instructions
SLIDE PRODUCT INTO THE
4
CUTOUT
• Carefully slide the unit into the opening. Be
careful not to entangle power cord.
beyond the surrounding cabinets.
LEVEL
5
Adjustable legs at the front corners of the
beverage center and wine chiller should be set
so the beverage center / wine chiller is firmly
to help the door closure.
To adjust the leveling legs, turn the legs
counterclockwise to raise the beverage center /
wine chiller, clockwise to lower it.
To raise the appliance
SET TEMPERATURE
6
CONTROLS
• The temperature controls are preset. Refer
to the Temperature Control section for more
information. Allow 24 hours for temperature to
13