Technical Features - STAYER WELDING TIG 200 HF P Mode D'emploi

5.- SERVICING AND MAINTENANCE INSTRUCTIONS
5.1.- Cleaning, maintenance, lubrication, sharpening.
For cleaning, always disconnect the equipment and wait at
least 10 minutes for the sake of safety regarding the discharge
of the power capacitors. Clean the housing using a slightly wet
cloth. Depending on the pollution of the work environment or at
least each 1000 hours, clean the inside with dry pressurized air,
removing the upper housing and removing dust, metal pollutants
and fluff, paying special attention to the dissipators and the fan.
The equipment does not need special maintenance by the user,
whereby careful use within the environmental limits is the best
guarantee for long years of safe service. It is recommended to
send the equipment to the technical services after each 3000
work hours or every 3 years for verification and recalibration.
5.2.- Repair services with directions.
STAYER IBERICA
Área empresarial Andalucía – Sector I
Calle Sierra de Cazorla, 7
Postal Code: 28320
Pinto (Madrid) SPAIN
List of user-replaceable parts
Due to the complexity and potential hazard, qualified intervention
is required, except for minor repairs as inspection of connections
and replacement of the standard power supply plug and revision
of the welding cables, which thus are not considered user-
replaceable parts.
ENGLISH
38
6.- Regulations

6.1.- Technical features

= tension input
= current input
= current output
%
= work cycle
ON
OFF EN60974
- -
= mass
= dimensions
- -
= generator power
We declare under our responsibility that the product described
under "Technical data" is in compliance with the standards or
following standard documents:
EN60974, 2004/108 / EC, 2006/95 / EC, 2002/96 / EC and
2003/11 / CE in accordance with the regulations 2006/42 / EC,
2014/30 / EU. According to WEEE / RoHS.
Ramiro de la Fuente
Director Manager
January, 2021
38