Frequently Asked Questions - Rona 2009615 Manuel D'utilisation

OPERATING INSTRUCTIONS
it is not used for a long period of time. Try to
recharge the battery and ensure the pack is
fully inserted into the charger.
Note: The battery will only fit into the charger
in one direction. The charger will not operate at
extreme temperatures.
2. The battery pack will not charge
Check to see if the battery is properly inserted
into the charger base and make sure the indicator
light illuminates when the battery is inserted – if
not, check the plug and fuse connected with the
power supply.
3. The trimmer does not cut properly
Check the condition of the trimmer head and
ensure the line is not too short. Replace the line
or the trimmer head.

FREQUENTLY ASKED QUESTIONS

1. Why does the trimmer handle get warm
during extensive use?
Under normal load condition the trigger, and
body will become warm because the battery
produces heat as it releases the energy required
to run the tool. This is normal.
2. The battery gets warm during use. Why?
The power draw from the battery generates
heat. This is increased as the energy draw
is increased. The battery pack will not be
damaged. This is normal.
3. I cannot fit the battery into the battery
charger. Why?
The battery can be inserted into the charger only
in one direction. Turn the battery around until it
can be inserted into the slot, the red LED light
should turn on when the battery is charging.
4. Reasons for different charging times.
Your charge time can be affected by many
reasons - which are not defects in your product.
If the battery pack is only partly discharged it
may be re-charged in less than 3 hours. If the
battery pack and ambient temperature are very
cold then re-charging may take 3 to 3 1/2 hours.
If the battery pack is very hot it will not re-charge
because the internal temperature safety cut-
out will prevent it. If hot you must remove your
battery pack from the charger and allow your
battery pack to cool first to ambient temperature
and then recharging can be started. If you
charge a second battery pack immediately after
the first then the charger can be over-heated.
Always allow at least 15 minutes rest between
battery pack charging.
5. Reasons for different battery pack working
times.
Charging time problems, as above, and having
not used a battery pack for a prolonged time will
reduce the battery pack working time. This can
be corrected after several charge and discharge
cycles by charging & working with your tool. Do
not re-charge your battery pack below 2
above 35 C as this will affect performance.
O
C and
O
A
29