Rona 2009615 Manuel D'utilisation page 27

OPERATING INSTRUCTIONS
Fig Q
Fig R
2. Operating the Trimmer
a) If you find that the nylon line is too short,
follow the instructions in the assembly section
to extend the line. Use the trimmer at an angle
of approximately 20º to the working area (see
Fig. N).
b) Do not overload your trimmer. Make small
passes in a semi-circular arc (see Fig O),
especially when cutting long grass. This will
keep the machine operating at a high speed
and will greatly improve the cutting efficiency
of the trimmer (see Fig. P and Q).
When cutting near fences, walls, flower beds,
etc. use the edge of the guard as a guide –
this will save damage to structures and plants
(see Fig. R).
3. Line Feeding
The trimmer uses 0.065" (1.65mm) diameter,
round nylon line to cut grass and weeds
quickly and easily. During use, the tip of the
nylon line will get shorter due to wear. Gently
bump the unit on the ground and the line will
feed out. The cutting line will wear faster and
require more feeding if the cutting or edging
is done along sidewalks or other abrasive
surfaces or when heavier weeds are being cut.
Fig S
Fig T
Fig U
Fig V
Fig W
A
27