Rona 2009615 Manuel D'utilisation page 28

OPERATING INSTRUCTIONS
Fig Y
Fig Z
3) Replacing the Cutting Line
Always remove the battery pack from the
trimmer before carrying out any maintenance.
Note: Always use replacement nylon trimmer
line that has a diameter of 0.065" (1.65mm). Do
not use metal or line made of other material.
a) To replace the nylon line, first remove the
spool cover from the spool holder by pushing
down on the centre of the spool and at the
A
same time firmly pressing the two spool cover
opening buttons on the side of the cutter head.
Remove the spool cover and remove the spool
(see Fig. S & T)
b) Remove the spool from the spool head cover.
c) Insert the replacement trimmer line through
28
the hole in the spool. Trimmer line should be no
Fig X longer than 10 feet (3m) in length (see Fig U).
d) Snugly and evenly wind the trimmer line onto
the spool in the direction of the arrow located on
the spool (see Fig. V).
e) Insert the trimmer line through the line
retaining slots located on the side of the trimmer
spool to hold the line in place (see Fig W). This
trimmer uses 2 lines. Repeat the procedure for
both trimmer lines.
f) To reconnect the spool into the spool head
cover, insert the trimmer lines through the brass
eyelets on the spool holder and pull the lines out
(see Fig X and Y).
g) Push the spool inwards against the spring clip
and then lower the spool cover firmly downwards
onto the trimmer and turn it clockwise until it
locks in position (see Fig Z).
Follow the instructions under the Assembly Section
to set the nylon line to the correct length.
MAINTAIN TOOLS WITH CARE
Your
lubrication or maintenance. There are no user
serviceable parts in your power tool. Never use
water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth. Always store
your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls
free of dust. If you see some sparks flashing in
the ventilation slots, this is normal and will not
damage your power tool.
TROUBLESHOOTING
1. The grass trimmer will not operate
Check that the battery pack is correctly inserted
into the trimmer.
Charge the battery: running of the trimmer is
dependent upon the sufficient charge in the
battery pack. The battery charge will deplete if
power tool requires no additional