Intended Use; Delivery Content - VOLTCRAFT 511100 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. Intended use

The power supply unit is designed to connect and operate low voltage consumers with an operating voltage of 13.8 V DC.
The voltage is taken from the two high current screw-type jacks on the back.
The power supply unit supplies a current of up to 120 amperes. The power consumption of a connected consumer
may not exceed this limit.
To compensate for line losses, a "SENSE" cable must always be connected. The output is short-circuit protected and
resets the output power in case of a short circuit.
The DC connection cables must have a large enough conductor cross-section for the corresponding current consump-
tion. If the conductor cross-section is too small, there is a risk of fire. For the rated current (120 A), the cross-section
of the conductor must be 35 mm
The switching power supply is designed in compliance with Protection Class 1. It is only approved for connection to
sockets with protective earthing contact and an alternating current of 230 V~/50 Hz, commonly used in households.
Operation in unfavourable ambient conditions is not permitted. Unfavourable ambient conditions include the following:
- Excessive moisture or humidity
- Dust and combustible gases, vapours or solvents
- Electrical storms or stormy conditions resulting in strong electrostatic fields, etc.
It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in bathrooms, must be avoided
under all circumstances.
For safety and approval purposes, you must not rebuild and/or modify this product. If you use the product for purposes
other than those described above, the product may be damaged. In addition, improper use can result in short circuits,
fires, electric shocks or other hazards. Read the instructions carefully and store them in a safe place. Make this prod-
uct available to third parties only together with its operating instructions.
All company names and product names are trademarks of their respective owners. All rights reserved.

4. Delivery content

• High current switching power supply
• Operating instructions
Up-to-date Operating Instructions
1
Download the latest operating instructions at www.conrad.com/downloads or scan the QR code
shown. Follow the instructions on the website.
.
2
15

Publicité

Table des Matières
loading

Table des Matières