Using The Internal Water Dispenser; Water Dispensing - Beko BBBF3019IMWESS Manuel D'utilisation

Operating the Product
5.16 Using the Internal Water
Dispenser
(May not be available in all models)
After connecting the refrigerator to the water
supply or replacing the water filter, press and hold
the water dispenser latch for 5 seconds and use
a durable container to clean the water system.
Then release the latch for 5 seconds, and keep
performing these procedures until water flows.
When the water starts to flow, repeat the same
steps until you discharge 15 liters of water. This
procedure will discharge the air in the filter and
water dispenser to make the water system ready
to use. Water may rush from the dispenser when
air comes from the system.
It will take the water 24 hours to cool down to
the temperature of the refrigerator after draining
large amounts of water and during the first filling
process.
The water dispenser will stop
dispensing to prevent flooding after the
C user has taken water continuously for
60 seconds. Press the dispenser latch
again to continue taking water.
Please call the authorised service if
A you see water leakage on the product
after it has been connected to the
water supply.
It is normal that a few drops of water
C
drop from the dispenser after you have
taken water.

5.17 Water Dispensing

Press the water dispenser latch and hold a vessel
under it at the same time.
Release the dispenser latch to stop dispensing
water.
C
It is normal for the first few glasses of
water taken from the dispenser to be
warm after the product has just been
connected to the water supply.
C
If the water dispenser has not been
used for a long time or if it is going
to be used for the first time, dispose
of the first 6 glasses of water to get
clean water.
26 / 35 EN
Refrigerator / User Manual